
Easy and fast cleaning
Rubber mixing tube
This mixing tube is robust conceived due to the multiply mesh insert for an easy and quick cleaning. It can be removed easily without any tools.
Dosing and mixing shaft
The new and revolutionary dosing and mixing shaft as one unit without middle axle. This means no sticking of the material and the cleaning is as easy and fast as never.
Mortar outlet
The rubber outlet is produced by one piece. In case that material sticks it can be removed easily and fast.
Rest material zone
This zone can be cleaned easily and fast thanks to the swinging drive and due to the optimised dry area there is no waste of material.
Control unit
Simple control unit in 400 V
Turnable dosing shaft segment
It is especially economical as it can be used twice. If the wearing requests it, the segment can be turned by 180°. Thanks to this the endurance is doubled.
Protected gear
An adapter with open sealing saves the shaft seal of the gear.
Rubber dosing zone
The test on hard construction sites shows: rubber is significantly longer living as steel. This saves money!
Combinable with PFT conveying pumps
For mortar transports we recommend our PFT conveying pumps, as e. g. PFT N 2 or PFT ZP 3
Further advantages:
- Conveying capacity can be increased up to 60/90 l/min. Special dosing shafts are optional available.
- Best varnishing due to burning the powder paint at 200°.
- It can be assembled by only one person. Thanks to the mounting device with integrated crane loops.
- Safety regulations correspond to the CE-regulations.